key features: ? 15w output power ? wide 2:1 input range ? high ef? ciency ? 1,500 vdc isolation ? single and dual outputs ? >1.12 mhour mtbf ? -40c to +85c operation mc1500xrw high performance, 15w wide input range dc/dc con vert ers input parameter conditions min. typ. max. units input voltage range 12 vdc input 9.0 12.0 18.0 vdc 24 vdc input 18.0 24.0 36.0 48 vdc input 36.0 48.0 72.0 input filter internal capacitors output parameter conditions min. typ. max. units output voltage accuracy 1.0 % line regulation v in = min to max 0.5 % load regulation, i out = 0% to 100% single output 0.5 % dual output, see note 1 0.5 ripple & noise (20 mhz), see note 2 100 mv p - p temperature coef? cient 0.02 %/c output overload protection 140 %i out output short circuit continuous (autorecovery) general parameter conditions min. typ. max. units isolation voltage input/output 3 seconds 1,500 vdc isolation voltage case/input or output 1,000 vdc isolation resistance 500 vdc 1,000 m? isolation capacitance 100 khz, 0.1v 1,000 pf switching frequency 125 khz environmental parameter conditions min. typ. max. units operating temperature range ambient -40 +25 +85 c operating temperature range case +100 c storage temperature range -40 +125 c cooling free air convection humidity rh, non-condensing 95 % physical case size 2.00 x 2.00 x 0.40 inches (50.80 x 50.80 x 10.16 mm) case material metal case, epoxy base (ul-94v0) weight 2.1 oz (60.0g) reliability speci cations parameter conditions min. typ. max. units mtbf mil hdbk 217f, 25c, gnd benign 1.121 mhours absolute maximum ratings parameter conditions min. typ. max. units input voltage surge (0.1 sec) 12 vdc input -0.7 25.0 vdc 24 vdc input -0.7 50.0 48 vdc input -0.7 100.0 lead temperature 1.5 mm from case for 10 sec 260 c caution: exceeding absolute maximum ratings may damage the module. these are not continuous operating ratings. series www.micropowerdirect.com micropower direct 292 page street suite d stoughton, ma 02072 usa t: (781) 344-8226 f: (781) 344-8481 e: sales@micropowerdirect.com w: www.micropowerdirect.com electrical speci cations speci cations typical @ +25?, nominal input voltage & rated output current, unless otherwise noted. speci cations subject to change without notice.
model selection guide micropower direct we power your success - for less! 292 page street ste d stoughton, ma 02072 ? tel: (781) 344-8226 ? fax: (781) 344-8481 ? e-mail: sales@micropowerdirect.com www.micropowerdirect.com model number input output output capacitive load (f max) ef ciency (%, typ) fuse rating slow-blow (ma) voltage (vdc) current (ma) voltage (vdc) current (ma, max) current (ma, min) nominal range full-load no-load mc1512s-03rw 12 9.0 - 18.0 1,031 30 3.3 3,000 0.0 3,300 80 3,000 mc1512s-05rw 12 9.0 - 18.0 1,524 30 5.0 3,000 0.0 3,300 82 3,000 mc1512s-07rw 12 9.0 - 18.0 1,506 30 7.2 2,083 0.0 2,200 83 3,000 mc1512s-09rw 12 9.0 - 18.0 1,470 30 9.0 1,666 0.0 1,000 85 3,000 mc1512s-12rw 12 9.0 - 18.0 1,470 30 12.0 1,250 0.0 1,000 85 3,000 mc1512s-15rw 12 9.0 - 18.0 1,470 30 15.0 1,000 0.0 680 85 3,000 mc1512s-18rw 12 9.0 - 18.0 1,470 30 18.0 833 0.0 470 85 3,000 mc1512s-24rw 12 9.0 - 18.0 1,453 30 24.0 625 0.0 470 86 3,000 MC1512D-03RW 12 9.0 - 18.0 1,031 30 3.3 1,500 0.0 1,500 80 3,000 mc1512d-05rw 12 9.0 - 18.0 1,524 30 5.0 1,500 0.0 1,500 82 3,000 mc1512d-07rw 12 9.0 - 18.0 1,506 30 7.2 1,041 0.0 1,000 83 3,000 mc1512d-09rw 12 9.0 - 18.0 1,488 30 9.0 833 0.0 680 84 3,000 mc1512d-12rw 12 9.0 - 18.0 1,488 30 12.0 625 0.0 470 84 3,000 mc1512d-15rw 12 9.0 - 18.0 1,488 30 15.0 500 0.0 330 84 3,000 mc1512d-18rw 12 9.0 - 18.0 1,470 30 18.0 416 0.0 220 85 3,000 mc1512d-24rw 12 9.0 - 18.0 1,470 30 24.0 312 0.0 220 85 3,000 mc1524s-03rw 24 18.0 - 36.0 515 25 3.3 3,000 0.0 3,300 80 1,500 mc1524s-05rw 24 18.0 - 36.0 744 25 5.0 3,000 0.0 3,300 84 1,500 mc1524s-07rw 24 18.0 - 36.0 744 25 7.2 2,083 0.0 2,200 84 1,500 mc1524s-09rw 24 18.0 - 36.0 735 25 9.0 1,666 0.0 1,000 85 1,500 mc1524s-12rw 24 18.0 - 36.0 735 25 12.0 1,250 0.0 1,000 85 1,500 mc1524s-15rw 24 18.0 - 36.0 726 25 15.0 1,000 0.0 680 86 1,500 mc1524s-18rw 24 18.0 - 36.0 726 25 18.0 833 0.0 470 86 1,500 mc1524s-24rw 24 18.0 - 36.0 726 25 24.0 625 0.0 470 86 1,500 mc1524d-03rw 24 18.0 - 36.0 515 25 3.3 1,500 0.0 1,500 80 1,500 mc1524d-05rw 24 18.0 - 36.0 753 25 5.0 1,500 0.0 1,500 83 1,500 mc1524d-07rw 24 18.0 - 36.0 744 25 7.2 1,041 0.0 1,000 84 1,500 mc1524d-09rw 24 18.0 - 36.0 735 25 9.0 833 0.0 680 85 1,500 mc1524d-12rw 24 18.0 - 36.0 726 25 12.0 625 0.0 470 86 1,500 mc1524d-15rw 24 18.0 - 36.0 726 25 15.0 500 0.0 330 86 1,500 mc1524d-18rw 24 18.0 - 36.0 726 25 18.0 416 0.0 220 86 1,500 mc1524d-24rw 24 18.0 - 36.0 718 25 24.0 312 0.0 220 87 1,500 mc1548s-03rw 48 36.0 - 72.0 257 20 3.3 3,000 0.0 3,300 80 750 mc1548s-05rw 48 36.0 - 72.0 372 20 5.0 3,000 0.0 3,300 84 750 mc1548s-07rw 48 36.0 - 72.0 372 20 7.2 2,083 0.0 2,200 84 750 mc1548s-09rw 48 36.0 - 72.0 367 20 9.0 1,666 0.0 1,000 85 750 mc1548s-12rw 48 36.0 - 72.0 363 20 12.0 1,250 0.0 1,000 86 750 mc1548s-15rw 48 36.0 - 72.0 359 20 15.0 1,000 0.0 680 87 750 mc1548s-18rw 48 36.0 - 72.0 359 20 18.0 833 0.0 470 87 750 mc1548s-24rw 48 36.0 - 72.0 359 20 24.0 625 0.0 470 87 750 mc1548d-03rw 48 36.0 - 72.0 257 20 3.3 1,500 0.0 1,500 80 750 mc1548d-05rw 48 36.0 - 72.0 372 20 5.0 1,500 0.0 1,500 84 750 mc1548d-07rw 48 36.0 - 72.0 372 20 7.2 1,041 0.0 1,000 84 750 mc1548d-09rw 48 36.0 - 72.0 367 20 9.0 833 0.0 680 85 750 mc1548d-12rw 48 36.0 - 72.0 363 20 12.0 625 0.0 470 86 750 mc1548d-15rw 48 36.0 - 72.0 359 20 15.0 500 0.0 330 87 750 mc1548d-18rw 48 36.0 - 72.0 359 20 18.0 416 0.0 220 87 750 mc1548d-24rw 48 36.0 - 72.0 359 20 24.0 312 0.0 220 87 750 notes: 1. load regulation is specit ed for a load change of 10% to 100% for dual output units. 2. when measuring output ripple, an external 1 f ceramic capacitor & 10 f electrolytic capacitor should be placed in parallel from the +vout pin to the -vout pin for single output models, or from each output to common for dual output models. 3. these converters are specit ed for operation without external components. however, in some applications the addition of 10 f capacitor across the input will enhance stability and performance. 4. it is recommended that a fuse be used on the input of a power supply for protection. see the model selection table above for the correct rating. mechanical dimensions notes: all dimensions are typical in inches (mm) tolerance x.xx = 0.02 ( 0.50) derating curve pin single output 1+v in 2-v in 3+v out 4 no pin 5-v out pin dual output 1+v in 2-v in 3+v out 4 common 5-v out pin con nec tions
|
